JENSEN JWM60A INSTALLATION AND OWNER'S MANUAL Pdf Download (2024)

FAQs

What is the difference between Jensen JWM60A and JWM62A? ›

The # JWM60A and the # JWM62A are the same unit, they're just manufactured in different countries.

Press any of the three buttons to turn the corresponding speaker zone on or off. SPK A (Zone A), SPK B (Zone B) or SPK C (Zone C) will appear on the display. Use a ball point pen or similar object to press the RESET button (28). This may be necessary should the unit display an error code.

According to Jensen, resetting the stereo should fix your problem. Just to the right of the CD/DVD eject button is a small hole. If you straighten out a paper clip and push it in that hole, there's a small reset button. Press the button and the stereo will reset itself.

Press and hold the MODE DISPLAY button (5) for 2 seconds to enter to clock mode. Press and hold ALARM ON/OFF button (22) for 2 seconds and the clock displayed on the LCD will be flashing. Then, press the |<< button (15) to adjust the hour or press the >>| button (16) to adjust the minute.

A moving coil microphone works on the principle of electromagnetic induction. Sound waves from the source hits the diaphragm of the microphone which vibrates and then is converted to electrical energy through magnetic coils whereas electrical signal is converted into sound waves in case of loudspeakers.

A single voice coil has one winding coil and a dual voice coil has two separate windings. Since both coils are energized, they perform the same as one with no difference other than wiring connection options.

On the edge of the speaker where the mounting holes are there will be a six digit number. The first three numbers will be 220 which denotes the manufacturer as Jensen. The next number is the year of manufacture and the last two numbers will be the week of manufacture. In this case, "220" is the Jensen manufacture code.

If you have power running to the unit but still can't get it to power on you may have a loose or blown fuse. The fuse of the Jensen RV Stereo - Single DIN - AUX/USB, Bluetooth, jControl - 12V # JWM70A is located on the rear of the unit by the wiring harness port. Try replacing the fuse with a new 10amp fuse.

Ensure no discs are playing in the DVD player. On the DVD remote control, press the UP ARROW or DOWN ARROW button to select the SETUP icon. Press the ENTER button. Press the UP ARROW or DOWN ARROW button to select RESET .

Ensure that the disc has been inserted into the player correctly. Examine the DVD for fingerprints, smudges, or scratches and, if necessary, clean the disc using a soft dry cloth. Ensure the disc has been properly created and finalized. Ensure the DVD region code and format of the disc is compatible with the player.

How do I set my Jensen time? ›

Time Menu Setup

Press & Hold the TIME button (7) to access time menu settings. Press the TIME button (7) repeatedly to adjust the following time menu list: ALARM (ON/OFF), ALARM SET, SLEEP TIMER and CLOCK SET. Use the or buttons (12, 11) to choose a value for each setting.

General Operation

Press the button to turn the unit on. Press again to turn the unit off. Press MODE to select between Radio, USB, Bluetooth, AUX. Modes of operation are shown in the display.

RESET <ENTER>: Press the ENTER button to return the JWM72A to factory default settings. When a portable audio device is connected to the unit, press the MODE button (15) repeatedly until FRONT AUX / REAR AUX mode is selectable, then press ENTER (4) knob to enter the FRONT AUX / REAR AUX mode.

dimensions: 10-1/2"W x 6-3/4"H x 7"D.

Appearance. The FF may be distinguished from the Interceptor by a few styling cues, the most obvious being the twin (rather than single) diagonal air vents on the front wing, just rear of the wheel-arches. The frontal appearance was revised in September 1968. Only coupés were made; there were no convertibles.